How to sheathe and warm the house with his own hands foam

Deciding to do paneling and insulation at home, you need enough meticulous approach to the selection of a material by a detailed study of all its features and specifications. The selected material should have excellent heat-saving, hydro - and sound insulating properties. In this case, it must be one which would not be injurious to health, that is environmentally friendly. Moreover, its price should be affordable. Today, on an ample variety of building materials market. But the most under the above criteria is suitable foam. This material is used to insulate homes for over 40 years.

Before starting work, make measurements. To calculate this area of ​​the walls and define the desired amount of material. foam sheets better to choose a sufficiently dense, but wherein their thickness should not exceed 50-80 mm. Then plasterer proceed directly to work.

In addition to the foam sheathing, we need to purchase the house:

- primer;

- plinth rail;

- mounting adhesive mixture or adhesive for tiles;

- reinforced mesh;

- putty for exterior or decorative plaster;

- paint;

- punch;

- dowel;

- notched trowel;

- knife.

This is followed by a preparatory stage - clearing, leveling, sealing cleavage and priming the walls. The smoother the wall, the less the consumption mounting adhesive mixture or adhesive for tiles. Zagruntuem walls and let them dry.

With the help of a spirit level set the plinth rail.

Installing sheet foam that will hold the mounting adhesive mixture or adhesive for the tiles. In the preparation of the mixture should be noted that it should be moderately thick, but at the same time no liquid that did not flow down on the surface. Using a notched trowel to apply adhesive sheet and the central part of its perimeter with indentation 2 cm. from the edge. Attach it to the wall and press gently. We fix the sheet using the punch and anchors at the corners and in the center, that is, in five locations. Each subsequent row will be installed with an offset. It is necessary to glue and the joints between the sheets.

Once we fully will fix all the foam proshpaklyuem it all the same cooked glutinous mixture. That the surface was not cracked, on top of the glue putty reinforced mesh, which had been previously we shall cut strips along the entire length of the wall.

Plaster walls will be the next day. For this we use decorative plaster or finish putty for exterior use. The last stage - the painting will be performed after the drying plaster surface.

Thank you for watching!Enjoy your day, and if not difficult to put Like and do not forget to subscribe!

  • Share: